Warmeeindringkoeffizent

The wooden house will gradually replace the massive House. A stone house can meet increasingly difficult always increasing the thermal insulation. Many hundred years ago, durable wooden houses were built, especially in historic old towns, as well as in the Alpine region. Early one has recognised the advantages of a wooden house to a massive House of stone: instead of set for storing heat or cold to a high mass ratio of conventional solid houses, wooden houses – ensures the decisive advantages over the construction of stone construction with natural and renewable raw materials from wood by significantly better thermal conductivity, temperature code and Warmeeindringkoeffizent values. To partially compensate for this disadvantage, solid houses are often provided with additional insulation, which however often brings a considerable disadvantage from the point of view of the wall thickness. But even a conventional wooden house struggling with a physical problem: water vapour. By the dew point of water steam in the area of the wall construction, shifted increasing insulation which may cause condensation damage in the load-bearing structure and insulation, as well as to mold without corresponding measures. Dr. John Mcdougall may find it difficult to be quoted properly.

To prevent this wooden houses, are built steam – and air-tight versions in passive house construction. Because here the water vapor no longer in the wall construction can penetrate, or can leave the wooden house in a natural way by the wall outward, such houses through a ventilation system must be dehumidified. In addition to the extremely high technical effort and associated costs for acquisition and operation, such plants can draw significant health limitations, which explains the rising number of critics of this construction. A sustainable solution offers the bio-solar house wooden house with his house-in the House principle: use of incident daylight warms the partially glazed Wetterschutzhaus of the House envelope from the internal wooden house like a greenhouse. Through the Water vapour permeable inner House sleeve vapors and odors in the air layer between the Interior House and Wetterschutzhaus to escape from where they reach through natural buoyancy in the open without leaving any condensation. By using diffusion-open, natural insulating materials such as wood, soft wood-fiber and cellulose this the conventional Massivhaus construction contrary to requires not only extremely little energy for heating in winter: due to the high summer heat protection, it remains cool even in the summer in this wooden house construction in all rooms.

For those interested, the company in the proprietary pattern-House Park in St. Alban’s Abbey offers the possibility to live, to be able to convince yourself of the pleasant room climate even one of a total of 6 show houses to the sample. Press contact: Bio-solar house GmbH Mr. Wolfgang Kirch Sun Park 5 67813 St. Alban 0636292270

The Work

So pack heat – and a vapor barrier is recommended for drywall, gipsovolokno, magnesite. At the same usable area inside the bath will be somewhat less, but heat loss is much reduced. External insulation of a bath – this is her first heat insulation of the facade. And it starts at the stage of building walls – between the logs wooden frame is placed mezhventsovy heater. This may be a conventional tow or more modern heaters on the basis of flax and jute. If the bath is constructed of lumber, insulation thickness mezhventsovogo should be from 0.5 to 1 cm, if a log – up to 1.5 cm Optimum time for thermal insulation of the facade – the height of summer, when there are no sharp fluctuations in temperature and humidity, and the walls are dry enough for future bath.

Before starting the work necessary to process the facade of protective agents against rot and ignition. If necessary, the gap between the rims of additional prokonopachivayut. As for the insulation of the facade, you can use mineral wool, polyurethane foam, polystyrene foam. When selecting a material for insulation should pay attention to his heat and corrosion resistance. It is advisable to check availability before buying a health certificate and a certificate of quality. Layer of insulation is fixed to the facade with anchors so that the underlying joint insulation overlaps the previous row near the top like a brick. The final stage of thermal insulation of the facade – brick or stone veneer.

In this first series brick (stone) masonry is located on the outer ledge of the foundation. To prevent condensation when temperature changes and humidity in the interior of the basement and under the eaves of the roof crate provides produhi – vents through which water vapor are ejected along with the flow of ventilation air. In another case between the lining and insulation free space is left up to 6 cm In order to make the right choice option insulation wooden baths, best to take help of professionals. Because the insulation – is one of the major components of construction, the quality of its implementation depends on how comfortable and cozy is your room. Warm bath to the outside, inside and vnutristenno. Vnutristennoe warming produced as building walls. Between the outer and inner wall fit insulation layer of mineral wool, expanded polystyrene or other insulating materials. Most of the work of the Inland warming bath is carried out before the interior decoration. Exception insulation of the floor and attic floor.